There is no denying the fact that ink cartridges can be quite a costly acquisition. This is especially the case for those who use the product on a frequent basis. Nonetheless, there are individuals who are missing out on a key opportunity to be more cost efficient and friendlier to the environment at the same time as well. Instead of throwing your ink cartridge in the bin once it has run out, you can actually refill it. This is not only a great way of recycling but it is an excellent method of making your money go further too. Read on to discover all you need to know about refilling your printer cartridges.
Refilling Ink Cartridges
Firstly, it is important to be aware of the fact that you cannot continuously refill one cartridge and use it for the rest of your life. If only things were that easy! You will have to buy new cartridges after several refills. Most guidelines recommend approximately four refills from one cartridge. This may not sound like a lot. But, when you consider the fact that you are actually going to pay for one in five cartridges, compared to paying for the full five now, you see the huge difference. In fact, if an ink cartridge costs you say £20; at present you spend £100 on five cartridges, which through refilling you make a saving of £80. It’s definitely worthwhile. And you do your bit for the environment too because four ink cartridges aren’t getting needlessly used and dumped.
So, how do you refill your ink cartridges? Well, you will need to purchase a refill kit first and foremost. This will contain everything you require for the following procedure. You will begin the process by putting your empty cartridge onto a paper cloth. Now you need to find the hole that leads to the reservoir. Run your fingers across the label and you will note that there are actually several different holes. The one you require should be easily identifiable because it will contain sponge. Once you have done this you will then need to use something sharp and thin, like a pin, and pierce a hole in the top of the cartridge. This will be your refill hole.
How to insert the syringe
The next step is how to insert the syringe (which will have been supplied with the kit you have purchased) into the hole. You need to push it deep inside so that the sponge goes down to the bottom. Once you have done this it is now time to inject the ink. Please make sure you do this slowly. If you do it too quickly you will end up with air bubbles. As soon as you see the tiniest bit of overfill you need to finish the process. You will draw a small amount of the ink back into the syringe and then you will extract it from the cartridge. Again, you must do this slowly.
Once that step has been complete. Make sure you gently dab the cartridge with some kitchen towel. And finally all you need to do is cover it again. It is always a good idea to print a test page just to check that everything is working properly. Nonetheless, if you follow this guide in a step by step manner, then you should definitely achieve the outcome you are looking for.